Unbenannt

<%PostCommentPage%> <%PhotoAlbumPage%> <%ProfilePage%>

Solved! KTM Bench identified Bosch MEDC17 ECU failure

{ 07:29, 24 June 2020 } { 0 comments } { Link }


One user feedback: I have KTM Bench ECU programmer to test with different ecms

And always with the same message "Bosch MEDC17 (TC1724 /1728 / 1767 / 1782 / 1784 / 1797) Flash identification, entering reprogramming mode failure"

I have tested the same connection with another j2534 interface

And can connect with ecm obviously can't read

the ecu type is 1766.



Attach several images of the Bosch ECU type & its internal pcb, the connection diagram, the error messages:
Solved!  KTM Bench identified Bosch MEDC17 ECU failure 1
添加图片说明


Solved!  KTM Bench identified Bosch MEDC17 ECU failure 2

Solved!  KTM Bench identified Bosch MEDC17 ECU failure 3

Solved!  KTM Bench identified Bosch MEDC17 ECU failure 4

Solved!  KTM Bench identified Bosch MEDC17 ECU failure 5


obdexpress.co.uk engineer solution:

The cpu is tc1767,but you connect as tc1766,so your connection is wrong.



Finally, the problem is solved!



Here BOSCH MEV17.4.2 IROM TC1767 PSA 1033:

PLUGIN 286
Solved!  KTM Bench identified Bosch MEDC17 ECU failure 6
Solved!  KTM Bench identified Bosch MEDC17 ECU failure 7



DIRECT CONNECTION WITH TRASDATA SYSTEM

In order to perform the Trasdata direct connection with free wirings it will be necessary to

connect the POL4 pin and DSDO signal too. DSDO is the yellow wire on BDM connector of the

universal adapter F34TD003.

Solved!  KTM Bench identified Bosch MEDC17 ECU failure



DIRECT CONNECTION WITH NEWGWNIUS SYSTEM

In order to perform the NewGenius free wires connection you need the F32GN037

or F32GN037-B cable. BLUE wire = CNF1, GREY wire = BOOT


Solved!  KTM Bench identified Bosch MEDC17 ECU failure 9




DIRECT CONNECTION



Solved!  KTM Bench identified Bosch MEDC17 ECU failure 10




DIMA CONNECTION

Connect the 2 boot pin to the programming lay-by pin n. 10. Moreover it is necessary to

solder a third wire that must be connected to the CNF1 clamp on the DIMA.



Solved!  KTM Bench identified Bosch MEDC17 ECU failure 11
Solved!  KTM Bench identified Bosch MEDC17 ECU failure 12
Solved!  KTM Bench identified Bosch MEDC17 ECU failure 14

Credits to www.obdexpress.co.uk



{ Kommentar schreiben }

{ Last Page } { Page 6 of 213 } { Next Page }

Über Mich

Start
Mein Profil
Archiv
Freunde
Mein Photo Album

«  September 2020  »
MonTueWedThuFriSatSun
 123456
78910111213
14151617181920
21222324252627
282930 

Links


Kategorien


Letzte Beiträge

Unbenannt
How to register and update Creator C600
Enable/disable Cayenne 958 locking sound using Piwis II Tester
OBDSTAR Eagle Helps you: Detect Odometer Fraud
OBDSTAR Eagle Helps you: Detect Odometer Fraud

Freunde